![]() ![]() If you don't have a fan connected, the fan section will stay at 0RPM because nothing is being read on the RPM pin of the header, but you can change the duty cycle of the control section. Each fan/control combo corresponds to a single fan header. Each fan is controlled by a specific control. The "fan" section shows the RPM and the control section shows the Duty Cycle. So if you download and run LHM, it'll have something similar to HW info's sensor table and under the fans there will be two sections: one for fans and one for controls. It uses Libre Hardware Monitor as its backend. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |